HYGE - applications

HYGE^TM
Metering Pin Design Software

A refined software program is available to enable the engineer to design a metering pin to produce a desired pulse or modify an existing pin to produce a new pulse.

The pulse is entered into the program, along with desired test parameters (payload, weight, set volume, load volume and pressures. The program then produces a metering pin profile. This profile may be easily modified by changing pressure or length parameters to achieve desired effect on pin shape.

Design starting parameters available

Half Sine Wave Form
Saw Tooth Wave Form
Square Wave Form
Sine Square Wave Form
Piece Wise Wave Form
Sine Piece Wise Wave Form

The program then produces a metering pin profile.

Assuring that system operating parameters are not exceeded
Providing suggestions to assist with development.
Preview of the pin shape
Table providing plotted points and dimensions
- For machining fixed pin or modular pin design
- Acceleration and velocity at each point

This profile may be easily modified by changing pressure or length parameters to achieve desired effect on pin shape.

Click here for the Upgrade Options Page