HYGETM
Compressed Air Module
The
Compressed Air Module may be installed as a replacement for
an older existing system. It provides filtered/dry air at 3,000
PSI. The module is based on a steel framework module easily
set on place with fork lift or pallet jacks.
A tank farm (storage tanks) is pressurized to 4,500 PSI prior
to start of the fire sequence. This reserve is then used to
pressurize the load cylinder reducing the time required to charge
system for firing by removing the dependence of compressor pumping
speed. The output is regulated to the maximum operation pressure
of 3,000 PSI available to Load cylinder. If the tank farm and
cylinder reaches equilibrium a valve isolates tank farm and
completes Load cylinder fill with compressors only.
The
unit features the following equipment:
- Two
high pressure air compressors
- Oil-water
separator
- Microfilter
replaceable element air filter
- Refrigerated
air dryer
- Twelve
each storage tanks with 444 cu inch capacity each
- 2470
cu inch accumulator tank
- 6930
cu inch blow-down receiver tank
The
module is based on a steel framework ready for placement in
the customers facility. All piping is stainless steel and the
unit is pre-wired and piped so only one electrical power connection
is required.
